Ghosts of past

A little reminder of my favorite Halloween tutorial ever.

You can find full tutorial on this link.

DIY nuts necklace / Uradi sam: Ogrlica od matica

Supplies/Materijal:

- 4 large, 6 medium and 6 small nuts // - 4 velike, 6 srednjih i 6 malih matica

- approx. 1/2 meter of silver chain // - otprilike pola metra lančića srebrne boje

- 2 large and 2 small silver rings // - 2 velike i 2 male alkice srebrne boje

- 1 clasp // - 1 kopča

- silicon or superglue // - silikonski ili super lepak

Arrange nuts like shown on picture below, and then glue them together one by one. // Poređajte matice po šablonu sa slike ispod i zatim ih zalepite jednu po jednu u takvu formaciju.

Wait fot it to dry completely. Put larger rings through nuts at the ends of this pendant and then put them through silver chain. Cut the chain in half and insert two smaller rings and clasp at the ends of the chain. // Kada se lepak potpuno osuši, provucite dva veća prstena kroz matice na kraju priveska ,a zatim i kroz lančić. Isecite lančić na dva jednaka dela i zakačite dve manje alkice i kopču.

DIYing lately

DIY glittery star hair piece / Uradi sam: Snala sa sljokicastom zvezdom

Material:  /   Materijal: 

-paper star cutout   /   -papirna zvezda željenog oblika i veličine

-white felt sheet   /   -beli filc tabla

-non/white chalk   /   -kreda u boji

-scissors   /   -makaze

-glue   /   -lepak

-small brush   /   -četkica za nanošenje lepka

-glitter   /   -šljokice

- hairpin   /   -ukosnica

Put your paper star on top of the felt and draw around it with chalk and cut it out.

---------------

Precrtajte šablon kredom na filc i isecite.

Evenly apply glue all over the felt star and cover with glitter.

---------------

Stavite malo superlepka na sredinu filcane zvezde, razmažite četkicom po celoj površini i ravnomerno posipajte šljokicama.

When completely dry, brush off excess glitter and apply thin layer of glue to fixate it.

---------------

Kada se osuši, otresite višak sljokica i pažljivo premažite tankim slojem lepka kako biste fiksirali šljokice. Bilo koji "beli" lepak iz knjižare može poslužiti, pošto su svi oni providni kada se osuše.

Cut out small rectangular piece of felt, pull through hairpin ,apply glue and paste together with bottom side of your star.

---------------

Kada se zaštitni sloj osuši, secite malo parče filca, provucite kroz ukosnicu i zalepite sa donje strane zvezde.

Hope you like it!

DIY: Bug brooch / Uradi sam: Broš buba

Osnovni materijal koji sam koristila je crni filc za telo i beli za krila, a isekla sam ih korišćenjem šablona od papira i krede, kao i u ovom postu.

Osim toga, potrebno vam je:

-pljosnate šljokice , po mogućstvu crna i providna sa odsjajem u bojama duge, ali može i crna, srebrna ili zelena, izgleda dobro u svakoj varijanti

-crni konac i igla

-bele šljokice (može i srebrne, naročito dobro izgleda ako i za oči koristite srebrne pljosnate šljokice)

-četiri iglice sa zatopljenim vrhom za noge

-malo mrežastog belog materijala isečenog kao i krila, da im doda malo dimenzije (možete koristiti til, ili bilo kakav koji vam padne pod ruku, moj je konkretno isečen od materijala u koji se umotavaju buketi #snadjise :)

Pored ovoga, trebaće vam običan beli lepak, četkica kojom ćete da ga nanosite, kopča za broš i opciono crni vodootporni marker.

Supplies:

-black felt for the body and white for wings ( I used paper stencil and chalk to cut it out, like in this post)

-white glitter for wings and flat glitter beads for eyes ( I used black and rainbow because I had those on hand, silver and green also look good)

-four pieces of wire with flat or ball ending for the legs

-needle and black thread

-some white net to give wings some dimension

-white glue, small brush (for glue), pin clasp and black waterproof marker (optionally).

------------------------------------------------------------

Provucite crni konac kroz iglu i "proštepajte" telo bube. Ovaj korak nije neophodan, ali krajnji proizvod izgleda mnogo bolje sa njim. Ne preporučujem da ovo pokušate na mašini, moja je jednostavno pojela filc, pa sam morala opet da ga sečem. Proces traje oko 10 minuta.

Use needle and black thread to stitch the body to add some dimension to it. This step is not necessery, but looks really nice. It took me around 10 minutes to do it.

----------------------------------------------------------

Namažite krila lepkom i posipajte šljokicama. Kada se osuši, prekrijte još jednim tankim slojem lepka da biste fiksirali šljokice.

.

Use brush to evenly apply glue all over "wings" and cover them with glitter. When it is completely dry, cover with thin layer of glue to fixate glitter.

----------------------------------------------------------

Odredite poziciju krila postavljanjem mrežice, a zatim zalepite krila na filc tako da malo mrežice viri ispod.

Use net to set position of the wings and then glue together wings and body. Make sure that some of the net peek under wings, I think it looks much prettier like that.

----------------------------------------------------------

Savijte žicu za nogice prstima i zalepite je za filc. Orijentišite se tako da prednje nogice izviruju ispod krila, a zadnje budu savijene tako da prate liniju tela bube.

Bend the wire with your fingers. Glue it so that front "legs" peek under wings and back legs follow shape of the body.

------------------------------------------------------------

Udenite crni konac u iglu, napravite malo veći čvor na kraju i ušijte šljokice koje ste odabrali za oči uz samu ivicu "glave" bube.

Make slightly larger knot and sew "eye" on eachs side of bugs head.

-------------------------------------------------------

Isecite malu kockicu filca na koju ćete ušiti kopču za broš i zatim je zalepiti po sredini tela. Tako ćete fiksirati nogice i osigurati da krajevi žice ne zakačinju garderobu kada nosite broš. Kada se to osuši, broš je spreman za nošenje.

Cut small piece of felt, sew pin clasp to it and glue it to the bottom. This will fixate legs and secure your wardrobe from wire ends when you wear it. Wait for it to dry and it is ready to wear!

Mini dodatni korak: Uzmite crni vodootporni marker i ofarbajte žicu u crno. Ne preslikava se na garderobu, a meni izgleda lepše tako.

-----------------------------------------------------

Mini additional step: Use black waterproof marker to paint wire black. It doesn't transfer on clothes and looks much better in my opinion.

Now it's definitely done:)

Hope you like it!

Is this bugging you?

The bug trend: love it or hate it?
I resisted for a while, and now I just adore it.

This is my own spin on it.

Like it? Stay tuned because later this week I will post DIY bug brooch tutorial :)

DIY heart bracelet / Uradi sam: narukvica sa srcem

U prethodnom postu sam objasnila kako napraviti ovakav privezak , tako da je ovaj post neka vrsta nastavka .

 I na kraju jedan neverovatno jednostavan trik za stavljanje narukvice sebi. Sve sto vam treba je spajalica.

Nadam se da vam se dopada :)

DIY: Heart charm / Uradi sam: Privezak srce

Materijal koji vam je potreban:

-parče deblje žice

-klješta za sečenje žice

-lepak

-crveni konac

---------------------------------------------------------

Supplies:

-piece of wire

-wire cutter

-glue

-red thread

Savijte žicu u obliku srca tako da se krajevi spajaju sa strane. 

-------------------------------------------------------

Bend wire to form a heart shape and cut excess wire.

Stavite kap superlepka na spoj, zalepite početak konca i obmotajte celu žicu. Kada dođete do kraja, stavite još kap  suprlepka i kada se osuši, isecite višak konca.

---------------------------------------------------------

Put a drop of superglue where wires are joint and wrap thread all around the wire. When you are finished, put another drop of superglue and cut off excess thread.

Hope you like it :)